Current–voltage graphs

How does the current through a resistor, a filament bulb and a diode change as you change the voltage? Run the experiment, plot the graph, then compare all three.

The experiment

Test:
6.0 V

Current–voltage graph

I = current in amps (A) · V = potential difference in volts (V)

Results

Potential difference (V)Current (A)Resistance (Ω)

No readings yet. Set the variable resistor and press Record reading, or Run the full test.

Equipment

These are the circuit symbols you need to learn for this practical.

The circuit diagram

Swap the fixed resistor for the filament lamp or the diode to test the other components.

Method

  1. Set up the circuit with the component in series with the ammeter, the variable resistor and the power supply. Connect the voltmeter in parallel across the component.
  2. Adjust the variable resistor to change the potential difference across the component.
  3. Record the potential difference on the voltmeter and the current on the ammeter.
  4. Repeat for at least six different potential differences, for example every 1 V.
  5. Reverse the connections to the power supply and repeat, to get negative readings.
  6. Plot current (y-axis) against potential difference (x-axis), and draw a line or curve of best fit.
  7. Repeat for the other components.

Getting good results

  • Independent variable: potential difference across the component. Dependent variable: current through it.
  • Control variables: use the same component throughout. For the resistor, keep the temperature the same by switching off between readings so it does not heat up.
  • Take each reading three times and calculate a mean to make the results more repeatable.
  • A diode needs a protective resistor in series. Without it, the current can rise so fast that the diode is destroyed.
  • Safety: wires and the bulb can get hot. Do not touch them while the current is flowing.

Summary of the results

Check your understanding

Why is the voltmeter connected in parallel and the ammeter in series?

A voltmeter measures the potential difference across a component, so it connects either side of it. An ammeter measures the current flowing through the component, so the same current must pass through both.

The graph for a fixed resistor is a straight line through the origin. What does this tell you?

Current is directly proportional to potential difference, so the resistance stays the same. The resistor is an ohmic conductor, as long as its temperature stays constant.

Explain why the graph for a filament bulb curves.

As the current increases, the filament gets hotter. The metal ions vibrate more, so the electrons collide with them more often. The resistance increases, so each extra volt gives a smaller increase in current and the graph levels off.

Describe the current–voltage graph for a diode.

In the reverse direction there is no current, because the diode has a very high resistance. In the forward direction there is almost no current until the potential difference reaches about 0.6–0.7 V, then the current rises steadily, in an almost straight line.

A resistor has a current of 0.25 A when the potential difference across it is 2.5 V. Calculate its resistance.

R = V ÷ I = 2.5 ÷ 0.25 = 10 Ω.

A filament bulb has a current of 0.2 A at 5 V. What is its resistance? Would the resistance be higher or lower at 2 V?

R = 5 ÷ 0.2 = 25 Ω. At 2 V the filament is cooler, so the resistance would be lower.